GorillaMaker.com Knowledge Base

Test Print for your GM3D Printer

To verify your printer is calibrated and printing correctly, download the appropriate Test Block file for your specific 3d printer. These were all created to print with PLA.

GM3D200 with a 0.4mm Nozzle - GM3D200-4mm-TestBlock.gcode

GM3D200 with a 0.8mm Nozzle - GM3D200-8mm-TestBlock.gcode

GM3D500 with a 0.8mm Nozzle - GM3D500-8mm-TestBlock.gcode

GM3D500/505 R2 with a 0.8mm Nozzle - GM3D500-505R2-8mm-TestBlock.gcode

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files (4)
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How to Calibrate your GorillaMaker 3d Printer
Viewed 1457 times since Mon, Dec 11, 2017
How to change the micro SD card on your GM3D500 3d Printer
Viewed 583 times since Mon, Dec 4, 2017
Has filament stopped flowing out the nozzle?
Viewed 212 times since Thu, Jun 6, 2019
Where do I find a 3d file to print?
Viewed 1021 times since Mon, Dec 4, 2017
What are the benefits of Dual Extruders
Viewed 693 times since Mon, Dec 4, 2017
Maintenance on your GorillaMaker GM3D200
Viewed 939 times since Sun, Dec 10, 2017
Performing Maintenance on your Extruder and Nozzle
Viewed 240 times since Thu, Jun 6, 2019
What materials could I 3d print with?
Viewed 1171 times since Mon, Dec 4, 2017
How to clean out your Extruder Gear
Viewed 1882 times since Sun, Dec 10, 2017