Has filament stopped flowing out the nozzle?
Article ID: 16 | Rating: Unrated | Last Updated: Thu, Jun 6, 2019 at 9:51 PM
There could be some residual filament left over. Glenn and Gabe show you up-close how to clear the jam in your nozzle. This procedure works on the GorillaMaker GM3D200, GM3D250, and GM3D505. Requires the brass rod located in your tool-kit.
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Viewed 3065 times since Mon, Dec 18, 2017
How to clean out your Extruder Gear
Viewed 2527 times since Sun, Dec 10, 2017
Maintenance on your GorillaMaker GM3D200
Viewed 1183 times since Sun, Dec 10, 2017
Change Filament on a GM3D200 3d Printer
Viewed 467 times since Sun, Dec 10, 2017