GorillaMaker.com Knowledge Base

Performing Maintenance on your Extruder and Nozzle

Has filament stopped flowing out the nozzle? There could be some residual filament left over. Glenn and Gabe show you up-close how to clear the jam in your nozzle and clean the hob gear of debris. This procedure works on the GorillaMaker GM3D200, GM3D250, and GM3D505.

 

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Test Print for your GM3D Printer
Viewed 1241 times since Thu, Mar 15, 2018
Has filament stopped flowing out the nozzle?
Viewed 172 times since Thu, Jun 6, 2019
Simplify3D Software
Viewed 2498 times since Mon, Dec 18, 2017
You just received your new GM3D5053D Printer, now what?
Viewed 1022 times since Sun, Aug 26, 2018
How to Calibrate your GorillaMaker 3d Printer
Viewed 1374 times since Mon, Dec 11, 2017
Change Filament on a GM3D200 3d Printer
Viewed 398 times since Sun, Dec 10, 2017
You just received your new GM3D200 3D Printer, now what?
Viewed 951 times since Wed, Mar 21, 2018
Maintenance on your GorillaMaker GM3D200
Viewed 891 times since Sun, Dec 10, 2017
How to clear a blinking error on your GorillaMaker #3dPrinter
Viewed 1176 times since Sun, Dec 10, 2017