Performing Maintenance on your Extruder and Nozzle
Article ID: 17 | Rating: Unrated | Last Updated: Thu, Jun 6, 2019 at 9:53 PM
Has filament stopped flowing out the nozzle? There could be some residual filament left over. Glenn and Gabe show you up-close how to clear the jam in your nozzle and clean the hob gear of debris. This procedure works on the GorillaMaker GM3D200, GM3D250, and GM3D505.
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
How to clean out your Extruder Gear
Viewed 2347 times since Sun, Dec 10, 2017
Test Print for your GM3D Printer
Viewed 1522 times since Thu, Mar 15, 2018
Maintenance on your GorillaMaker GM3D200
Viewed 1113 times since Sun, Dec 10, 2017
Viewed 2937 times since Mon, Dec 18, 2017
Change Filament on a GM3D200 3d Printer
Viewed 452 times since Sun, Dec 10, 2017