GorillaMaker.com Knowledge Base

How to clear a blinking error on your GorillaMaker #3dPrinter

Is your probe blinking? If the bed was too close to the probe when it was turned on will cause the light on the probe to blink. 

To Reset your sensor probe-

  • Tap Home
  • Tap Home All

Your 3d printer will now home and automatically reset your probe light. 

 

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How to change the micro SD card on your GM3D500 3d Printer
Viewed 596 times since Mon, Dec 4, 2017
You just received your new GM3D200 3D Printer, now what?
Viewed 1064 times since Wed, Mar 21, 2018
How to clean out your Extruder Gear
Viewed 1933 times since Sun, Dec 10, 2017
Test Print for your GM3D Printer
Viewed 1396 times since Thu, Mar 15, 2018
Maintenance on your GorillaMaker GM3D200
Viewed 1009 times since Sun, Dec 10, 2017
What are the benefits of Dual Extruders
Viewed 734 times since Mon, Dec 4, 2017
What materials could I 3d print with?
Viewed 1242 times since Mon, Dec 4, 2017
How to Calibrate your GorillaMaker 3d Printer
Viewed 1512 times since Mon, Dec 11, 2017
Has filament stopped flowing out the nozzle?
Viewed 251 times since Thu, Jun 6, 2019