GorillaMaker.com Knowledge Base

How to clear a blinking error on your GorillaMaker #3dPrinter

Is your probe blinking? If the bed was too close to the probe when it was turned on will cause the light on the probe to blink. 

To Reset your sensor probe-

  • Tap Home
  • Tap Home All

Your 3d printer will now home and automatically reset your probe light. 

 

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Test Print for your GM3D Printer
Viewed 1026 times since Thu, Mar 15, 2018
Performing Maintenance on your Extruder and Nozzle
Viewed 69 times since Thu, Jun 6, 2019
What materials could I 3d print with?
Viewed 909 times since Mon, Dec 4, 2017
Simplify3D Software
Viewed 2157 times since Mon, Dec 18, 2017
How to change the micro SD card on your GM3D500 3d Printer
Viewed 483 times since Mon, Dec 4, 2017
How to clean out your Extruder Gear
Viewed 1518 times since Sun, Dec 10, 2017
Maintenance on your GorillaMaker GM3D200
Viewed 767 times since Sun, Dec 10, 2017
You just received your new GM3D200 3D Printer, now what?
Viewed 785 times since Wed, Mar 21, 2018
How to Calibrate your GorillaMaker 3d Printer
Viewed 1132 times since Mon, Dec 11, 2017
Has filament stopped flowing out the nozzle?
Viewed 53 times since Thu, Jun 6, 2019