GorillaMaker.com Knowledge Base

How to clear a blinking error on your GorillaMaker #3dPrinter

Is your probe blinking? If the bed was too close to the probe when it was turned on will cause the light on the probe to blink. 

To Reset your sensor probe-

  • Tap Home
  • Tap Home All

Your 3d printer will now home and automatically reset your probe light. 


0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Security Code Security Code
Related Articles RSS Feed
Has filament stopped flowing out the nozzle?
Viewed 335 times since Thu, Jun 6, 2019
Change Filament on a GM3D200 3d Printer
Viewed 452 times since Sun, Dec 10, 2017
Test Print for your GM3D Printer
Viewed 1522 times since Thu, Mar 15, 2018
Where do I find a 3d file to print?
Viewed 1091 times since Mon, Dec 4, 2017
Performing Maintenance on your Extruder and Nozzle
Viewed 337 times since Thu, Jun 6, 2019
Maintenance on your GorillaMaker GM3D200
Viewed 1113 times since Sun, Dec 10, 2017
Simplify3D Software
Viewed 2937 times since Mon, Dec 18, 2017
You just received your new GM3D200 3D Printer, now what?
Viewed 1685 times since Wed, Mar 21, 2018
What materials could I 3d print with?
Viewed 1392 times since Mon, Dec 4, 2017
How to Calibrate your GorillaMaker 3d Printer
Viewed 1625 times since Mon, Dec 11, 2017