GorillaMaker.com Knowledge Base

How to clean out your Extruder Gear

 You will need your brass brush that came with your tool-kit. 

  • Tap Pre-heat
  • Tap + button until your preset is 220 degrees
  • Wait for hot-end to come up to temperature
  • Turn knob clock-wise while brushing the grooves in the hob gear. 
  • Tap Off to turn off the temperature. 

 

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Has filament stopped flowing out the nozzle?
Viewed 17 times since Thu, Jun 6, 2019
Test Print for your GM3D Printer
Viewed 886 times since Thu, Mar 15, 2018
How to clear a blinking error on your GorillaMaker #3dPrinter
Viewed 882 times since Sun, Dec 10, 2017
What materials could I 3d print with?
Viewed 828 times since Mon, Dec 4, 2017
Simplify3D Software
Viewed 1995 times since Mon, Dec 18, 2017
How to change the micro SD card on your GM3D500 3d Printer
Viewed 457 times since Mon, Dec 4, 2017
You just received your new GM3D200 3D Printer, now what?
Viewed 716 times since Wed, Mar 21, 2018
Change Filament on a GM3D200 3d Printer
Viewed 304 times since Sun, Dec 10, 2017