How to clean out your Extruder Gear
Article ID: 8 | Rating: Unrated | Last Updated: Sun, Dec 10, 2017 at 7:28 PM
You will need your brass brush that came with your tool-kit.
- Tap Pre-heat
- Tap + button until your preset is 220 degrees
- Wait for hot-end to come up to temperature
- Turn knob clock-wise while brushing the grooves in the hob gear.
- Tap Off to turn off the temperature.
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Change Filament on a GM3D200 3d Printer
Viewed 398 times since Sun, Dec 10, 2017
Where do I find a 3d file to print?
Viewed 999 times since Mon, Dec 4, 2017
Viewed 2498 times since Mon, Dec 18, 2017
Test Print for your GM3D Printer
Viewed 1241 times since Thu, Mar 15, 2018
What are the benefits of Dual Extruders
Viewed 642 times since Mon, Dec 4, 2017
What materials could I 3d print with?
Viewed 1093 times since Mon, Dec 4, 2017
Maintenance on your GorillaMaker GM3D200
Viewed 891 times since Sun, Dec 10, 2017