GorillaMaker.com Knowledge Base

How to clean out your Extruder Gear

 You will need your brass brush that came with your tool-kit. 

  • Tap Pre-heat
  • Tap + button until your preset is 220 degrees
  • Wait for hot-end to come up to temperature
  • Turn knob clock-wise while brushing the grooves in the hob gear. 
  • Tap Off to turn off the temperature. 

 

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How to clear a blinking error on your GorillaMaker #3dPrinter
Viewed 1380 times since Sun, Dec 10, 2017
You just received your new GM3D200 3D Printer, now what?
Viewed 1683 times since Wed, Mar 21, 2018
What materials could I 3d print with?
Viewed 1392 times since Mon, Dec 4, 2017
Where do I find a 3d file to print?
Viewed 1091 times since Mon, Dec 4, 2017
Test Print for your GM3D Printer
Viewed 1522 times since Thu, Mar 15, 2018
Change Filament on a GM3D200 3d Printer
Viewed 452 times since Sun, Dec 10, 2017
Maintenance on your GorillaMaker GM3D200
Viewed 1113 times since Sun, Dec 10, 2017
What are the benefits of Dual Extruders
Viewed 782 times since Mon, Dec 4, 2017