GorillaMaker.com Knowledge Base
GM3D500 Articles RSS Feed
Simplify3D Software
Viewed 3065 times since Mon, Dec 18, 2017
Simplify3d is another 3d slicing program that works with our 3d printers.  You can purchase and download their software here : https://www.simplify3d.com/ Download the Factory File and FFF Profile attached.  Once installed and opened: Click File... Read More
How to clean out your Extruder Gear
Viewed 2527 times since Sun, Dec 10, 2017
 You will need your brass brush that came with your tool-kit.  Tap Pre-heat Tap + button until your preset is 220 degrees Wait for hot-end to come up to temperature Turn knob clock-wise while brushing the grooves in the hob gear.  Tap Off to turn... Read More
How to Calibrate your GorillaMaker 3d Printer
Viewed 1703 times since Mon, Dec 11, 2017
You will need the slick sheet of paper that came in your toolkit. It’s approximately the same thickness of a sheet of paper. Pre-heat your 3d printer to 220 degrees C. Tap More -> Calibrate Slide your paper between the nozzle and bed. You... Read More
Test Print for your GM3D Printer
Viewed 1600 times since Thu, Mar 15, 2018
To verify your printer is calibrated and printing correctly, download the appropriate Test Block file for your specific 3d printer. These were all created to print with PLA. GM3D200 with a 0.4mm Nozzle - GM3D200-4mm-TestBlock.gcode GM3D200 with a 0... Read More
What materials could I 3d print with?
Viewed 1503 times since Mon, Dec 4, 2017
There are different materials for different situations. The most common are PLA and ABS. Check your specific printer for specific applications.  PLA - Polylactic acid.  A popular material among 3D printing enthusiasts. It is a biodegradable... Read More
How to clear a blinking error on your GorillaMaker #3dPrinter
Viewed 1436 times since Sun, Dec 10, 2017
Is your probe blinking? If the bed was too close to the probe when it was turned on will cause the light on the probe to blink.  To Reset your sensor probe- Tap Home Tap Home All Your 3d printer will now home and automatically reset your probe... Read More
How to change the micro SD card on your GM3D500 3d Printer
Viewed 677 times since Mon, Dec 4, 2017
If your 3d printer has the rotary dial screen, this video is for you.         Read More