GorillaMaker.com Knowledge Base

News & Announcements

  1. Updated MatterControl Settings for GM3D200
    Published on: Mon, Dec 18, 2017 at 8:19 PM | Viewed: 7606 times.
    If you are using MatterControl for your GM3D200, you will need to adjust the temperature on your settings.  Under Material PLA .4 click the pencil to the right Click on Filament -> Temperatures Change 230 to 220 If you are not using the newest version, you can download and install from this article.  Click here for M...... Read Full News

Subscribe to Knowledge Base

Get notified when new articles are added to the knowledge base.