GorillaMaker.com Knowledge Base

Updated MatterControl Settings for GM3D200

Published on: Mon, Dec 18, 2017 at 8:19 PM | Viewed: 7607 times.

If you are using MatterControl for your GM3D200, you will need to adjust the temperature on your settings. 

Under Material PLA .4 click the pencil to the right

Click on Filament -> Temperatures

Change 230 to 220

If you are not using the newest version, you can download and install from this article. 

Click here for MatterControl Software and instructions

Subscribe to Knowledge Base

Get notified when new articles are added to the knowledge base.