Has filament stopped flowing out the nozzle?


There could be some residual filament left over. Glenn and Gabe show you up-close how to clear the jam in your nozzle. This procedure works on the GorillaMaker GM3D200, GM3D250, and GM3D505. Requires the brass rod located in your tool-kit. 

 



Article ID: 16
Created On: Thu, Jun 6, 2019 at 9:51 PM
Last Updated On: Thu, Jun 6, 2019 at 9:51 PM
Authored by: Shelley Warner [sw@gorillamaker.com]

Online URL: http://gorillamaker.knowledgebase.co/article.php?id=16